Modern solid state electronic regulator for models with Bosch charging system

Bolts to original mounting point but this replacement part is not as tall as the old metal regulator. Also known as Guzzi ref. 17703800. Replaces ELA29704

See our Bosch fault finder page for help diagnosing problems on your Bosch charging system. The original type mechanical regulator is no loger available

 2 in stock

29703800-z 29703800 GU29703800 29 70 38 00
 2970 3800 2970.3800 29.70.38.00

Reconditioned starter motor and solenoid in black and silver finish. Professionally reconditioned and sold with a 12 month guarantee. This is a suitable replacement for Bosch 8 or 9 tooth Guzzi starter motors. See ELA14738 for replacement solenoid.

This may fit Loop frame models with 5 speed gearboxes, you will need to trim a clearance into the battery tray to make room. The clutch cable bracket will prevent fitment on 4 speed models.

This is an exchange only item, we can supply these before receiving your exchange unit subject to a refundable deposit so you can keep your bike on the road. See ELC10737 for the refundable deposit. Send your old starter motor to our registered address. NB In case of starter motor problems do not tap the casing as this will certainly cause it to fail. See SSA08075 for mounting bolts. Do not remove second nut from terminal posts when fitting - this nut is required to hold the terminal in place

 2 in stock

 14730554 GU14730554 14 73 05 54
 1473 0554 1473.0554 14.73.05.54

Thick shim washer for valve spring

Used as lower valve spring shim washer

 2 in stock

 13037200 GU13037200 13 03 72 00
 1303 7200 1303.7200 13.03.72.00

Piston ring set

4 ring set

 2 in stock

14060700-z 14060700 GU14060700 14 06 07 00
 1406 0700 1406.0700 14.06.07.00

Cylinder head breather pipe, head to breather box/airbox

Banjo connection at head, push fit to airbox/breather box, see ENA95990 for banjo bolt

 2 in stock

17159700-z 17159700 GU17159700 17 15 97 00
 1715 9700 1715.9700 17.15.97.00

Cam follower / tappet, standard size

Not for PI / hydraulic tappet models produced between 2003 and 2006

 2 in stock

 17045860 GU17045860 17 04 58 60
 1704 5860 1704.5860 17.04.58.60

36mm exhaust valve

Also known as Guzzi ref. 29036150

 2 in stock

 13036100 GU13036100 13 03 61 00
 1303 6100 1303.6100 13.03.61.00

Rubber grommet for clutch bell housing / flywheel timing hole

Timing hole plug or timing hole bung. Also used to fill holes used to mount Griso factory luggage rack

 2 in stock

93180220-z 93180220 GU93180220 93 18 02 20
 9318 0220 9318.0220 93.18.02.20

Central tank mount rubber, mounts on central frame tube

1 required, this is the only frame rubber used for the tank on small twins

 2 in stock

 14107100 GU14107100 14 10 71 00
 1410 7100 1410.7100 14.10.71.00

Black cable end rubber, used where choke and throttle cables enter carb tops and cable splitter boxes

 2 in stock

 13937000 GU13937000 13 93 70 00
 1393 7000 1393.7000 13.93.70.00